In our version of Barriss’ costume there is seven different pieces; cape, scarf, cowl, dress, belt, shoes and lightsaber. I’ve seen other costumers and cosplayers with different solution. Some have done separate shirt and skirt or cowl attached to the cape itself. You can’t really tell how the costume is constructed when it’s on, so I went on with a way that was most suitable for us and my way of costume making.
The cape fabric was something we really searched for. Finally we accepted this synthetic fiber mix we found from local fabric store. It has velvety or brushed cotton type surface, but the inside looks like what you would use in a shell suit. Gladly, the printing emulsion worked on the synthetic fabric. We used a stencil roughly a size of an A4 sheet and used pearly blue and silver opaque colors from EMO-tuotanto. Needless to say, the process took days! Still it was bit faster than printing Luminara’s cape.
The cape is pretty much straight pieces of fabric. The back is gathered to eight large folds, which I sewed on a shoulder panel. The front is double layered and lifted from the front to the tip of the shoulder and sewed on place. The hood is patterned rather freely, it’s supported by iron on backcloth and the whole thing is lined with black acetate. The cape has hidden hook fastening on the front.
The scarf is actually my old “pashmina” scarf I bought for few pounds from London. I just cut it in half and thus sacrificed it to cosplay goddesses.
The cowl is sewed from leftover pieces of the cape. It fastens with hooks on the back of the neck.
The dress has four different fabrics on it. The top layer of the shirt is made from two crinkled and detailed tricot fabrics. As a lining is used lycra tricot on the bust in two layers to prevent transparency. The hem is made from heavy knit fabric with 5% elastane to ensure decent fall and flow. To make the look on the middle section of the bust according to references, I sew pin tucks for more detailed look.
The hem is half circle as the upper part of it is more or less like a tube. I sew the shirt part and hem part separately and joined them as a last step. If I wish to change the hem, the cut on it is slightly lower than the reference because in my mind it fitted Yoki’s physique better, then I can do it easily without having to seam rip the sides.
Yoki made the belt buckle from pulp board, craft foam and some yarn. Here is a link to a post she made about it. The belt is made the same way as Luminara’s; with brown pleather on top and awning fabric on the back to give support. Barriss’ belt is little darker than Luminara’s, so I used a sponge to rub dark grey acrylic paint thinly on the pleather. It actually worked really well. The acrylic set on the pleather nicely and didn’t crack even if I tried stretching it.
The black boots were found from same second hand shop as Luminara’s. There are five decorative buckles on the sides and reasonable heel to walk. Price for the boots was something ridiculous, like ten euros.
The lightsaber Yoki made from pulp board tube this time from plastic wrap container, craft foam, putty, black electricity tape, silver spray paint and finally screws and plaster buttons as details.
0 komentar:
Posting Komentar